ASSEMBLY
ATTACHING THE LOWER FOOT
See Figures 1 and 2.
nPlace stand assembly “flat” on floor.
nRotate lower foot into upright position aligning holes as shown.
nLocate the following parts: Hex Bolt, M8 x 50 mm (2) Flat Washer, M8 (4)
Lock Nut, M8 (2)
nInstall bolt, two washers and lock nut as shown. Finger tighten lock nut.
nRepeat above step on the opposite side.
nTighten all four lock nuts.
Fig. 1
Fig. 2
MOUNTING WHEELS
See Figure 3.
n Slide axle bolt outwards until it extends beyond the frame.
nRemove axle lock nut and one washer.
WARNING:
Do not remove axle bolt(s) from the frame. Energy from gas spring can cause injury if leg is disconnected from axle bolt(s).
nPlace wheel on axle bolt as shown
nReplace axle lock nut and washer as shown. Tighten lock nuts securely. Check to see that the wheel freely spins. If not, slightly loosen axle lock nut. Repeat steps above steps for opposite wheel.
nPress plastic cap over each wheel lock nut by gently tapping with a hammer.
OUTWARDS
Fig. 3
6