2.Mount one blade assembly to the motor hub by mating the alignment post (Figure 11) of the flange with one of the alignment slots in the motor hub (Figure 12). Then tighten the two captive screws in the flange to secure the flange to the motor hub. Repeat this procedure for the other four blade assemblies. Make sure all screws are tightened.
MOTOR HUB
CAPTIVE | BLADE FLANGE | ALIGNMENT |
SCREW (2) |
| SLOT |
|
|
Figure 12
Installing The Glass Shades
1.To install the glass shade, squeeze the retaining clips towards the bulb socket and slide on the glass shade (Figure 13). The spring clips will seat the shade and secure it in place.
2.To remove the shade, simply pull it off with a twisting motion.
Removal Of The
Light Fixture
NOTE: In some instances it may be desirable to install the ceiling fan without the light fixture. If this is the case, proceed as follows. (You may want to keep the light fixture for possible future use.)
1.Remove and retain the three screws securing the light fixture to the switch housing (Fixture 14). Remove and retain two wire connectors and disconnect the light fixture from the switch housing.
SWITCH
SCREW (3) | HOUSING |
| |
| LIGHT |
| FIXTURE |
Figure 14
2.Use the wire connectors to securely cap the each of the two wires in the switch housing (Figure 15).
3.Position the switch housing cover (supplied) on the switch housing so that the notch in the cover clears the reversing switch. Install the three screws to secure the cover.
SQUEEZE |
| |
RETAINING | RETAINING | |
CLIPS | ||
CLIP | ||
TOGETHER | ||
| ||
AND SLIDE |
| |
ON GLASS |
| |
SHADE |
|
SWITCH
HOUSING
DISCONNECT TWO WIRES FROM LIGHT FIXTURE AND SECURELY CAP WITH WIRE CONNECTORS
SCREW (3)
SWITCH HOUSING COVER
GLASS |
SHADE |
Figure 13
Figure 15
8