Chief Manufacturing CTA-025 installation instructions Step, Attaching Front Cover

Installation Instructions CTA-025

STEP 2

Attaching Front Cover

1.Locate front cover (20) and four M4 x 8mm Phillips head cap screws (50).

NOTES

•The front cover may be partially removed and reinstalled to conceal power/audio/video cables after the TV/Mount is installed.

•You may remove one or both knockouts on cover to assist routing to wall through cover.

2.Install the front cover (20) using four M4 8mm Phillips head cap screws (50). See Figure 3.

(50)

(20)

Figure 3. Attach Front Cover

STEP 3

Connecting NPT Pipe or Nipple to Wall Arm

1.Locate M6 x 6mm set screw (60) and 1-1/2” NPT pipe or nipple (supplied with TV Mount or purchased separately).

2.Connect the 1-1/2” NPT pipe or nipple (supplied with TV Mount or purchased separately) to the wall arm (10). See Figure 4.

3.Using the M3 Allen key (70), install the M6 x 6mm set screw (60). Tighten the set screw.

WARNING

Make sure to tighten the M6 x 6mm set screw (60) to prevent equipment damage or personal injury.

(60)

(Supplied with TV Mount or purchased separately)

Figure 4. Connect NPT Pipe or Nipple to Wall Arm

6