Evaluation Board User Guide | |
|
|
INERTIAL SENSOR EVALUATION SYSTEM SETUP
SOFTWARE CONFIGURATION
Software configuration of the inertial sensor evaluation system involves installation of USB drivers for the ISEB and National Instruments LabVIEW®
Installing the USB Drivers for the ISEB
To install the USB drivers, follow these steps.
1.Execute the ADI_ISEB_USB_Drivers.exe file located in /Drivers/ISEB_USB/.
2.Follow the
3.Click Continue Anyway when prompted that the drivers are not tested.
It may be necessary to manually select the correct drivers after installation. To select the drivers, follow these steps.
1.Connect the USB A to
2.If prompted to install drivers again, click Install from a list or specific location (Advanced), see Figure 2.
Figure 2. Found New Hardware Prompt
3.Select Don’t search. I will choose the driver to install. (see Figure 3) and select ADI Inertial Sensor Evaluation System from the model list (see Figure 4).
The ISEB should be detected automatically in the Device Manager as the ADI Inertial Sensor Evaluation System under the Ports (COM & LPT) selection. It is recommended to open the Device Manager to verify hardware detection and to record the communication port associated with the ISEB for use in the GUI.
Figure 3. Selection of the Driver to Install
Figure 4. Selection of the ADI Inertial Sensor Evaluation System Drivers
Installing the LabVIEW and NI-VISA Run-Time Engines
After installing the USB drivers, install the LabVIEW and
1.Execute the LVRTE851std.exe file located in the /Drivers/ folder.
2.Follow the
3.Reboot the PC.
4.Locate and execute the visa441runtime.exe file located in the /Drivers/ folder to install the
5.Follow the
6.Reboot the PC.
Rev. 0 Page 3 of 12