Oregon Scientific atc-2k manual VI Quick Start, Battery Installation, Turning On the Camera

Page 8

VI) Quick Start

Battery Installation

1.Turn and pull to release the cover at the end of the unit.

2.Release the battery tray by pushing the release hook

with a pen or similar object.

3.Insert 2 x AA alkaline batteries into the battery tray with the polarity in the direction as shown.

4.Replace the tray and cover.

Be careful!! The edge of the clip is sharp, when turning and pulling the cover, make sure the clip is in the same direction as the lens. Observe the following precautions when turning and pulling the cover of the camera.

Important: When the camera is low in battery, the low battery icon will appear on the LCD display.

Always download video footages to your PC prior to replacing batteries to avoid memory loss.

Note:

a)Battery installation should be done under adult supervision.

b)Do not mix old and new batteries together. Replace

all the batteries at the same time.

c) Remove the batteries if the camera is not going to be used for long periods of time. This will save battery

11life.

d)Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used.

e)Non-rechargeable batteries are not to be recharged.

f)Rechargeable batteries are to be removed from the camera before being charged.

g)Rechargeable batteries are only to be charged under adult supervision.

h)Exhausted batteries are to be removed from the camera.

i)The supply terminals are not to be short-circuited.

Turning On the Camera

Press and hold the for 2 seconds (two beeping sounds). The LCD display will light up.

For your safety, do not press any buttons on the camera during sports activities.

Turning Off the Camera

1. Press and hold the for 2 seconds (two beeping sounds). The LCD display will turn off.

2. The camera will be turned off automatically after 10 minutes of not being used unless it is in USB mode.

12

Image 8
Contents ATC-2K Oregon Scientific ATC-2K Camera Precautions Water Resistant FeatureAdd one extra o-ring for more protection III Computer System Requirements Minimum System RequirementsIV Camera Description Camera Mounting Description Fixing the position of the cameraBattery Installation VI Quick StartTurning On the Camera Turning Off the CameraInserting/Removing the SD memory Card InsertRemove Taking Video FootageVII Menu Settings Different mode icons are shown in the table belowResolution 640 x 480, 320 x 240, 160 x 120 pixels resolution Setting Date/Time Clock Set Setting the YearSound Recording Deleting video footageSetting the Month Setting the DaySetting the Time SD Memory CardViii Connecting to PC Available Recording TimeTroubleshooting IX Playing back video footage on a TVATC-2K Website Theres no displayCant capture the video footage Page Oregon Scientific, Inc
Related manuals
Manual 18 pages 32.13 Kb