Inserting/Removing the SD memory Card

Note: If the camera is connected to your PC, you have to unplug the USB cable to turn off the camera.

Make sure the ATC-2K is turned off during the insertion or the removal of the SD card.

Warning: The card and the data may be damaged if the SD card is inserted or removed while the camera is on.

Insert:

1.Turn off ATC-2K

2.Turn and pull to release the cover at the end of the unit.

3. Insert the card carefully and completely.

4. Close the cover at the end of the unit.

Remove:

1.Turn off ATC-2K

2.Turn and pull to release the cover at the end of the unit.

3. Push the card until it clicks, then pull the card out. 4. Close the cover at the end of the unit.

Note:

a. Make sure the card is inserted correctly b. Do not touch the connect terminals on the back

of the SD card.

c. The card may be damaged if it is not fully inserted.

d. The card and the data may be damaged if the SD card is inserted or

13removed while the camera is still on.

Taking Video Footage

1. Aim at the subject you want to shoot. 2. Press the 'Movie shutter button' to start recording.

(One beeping sound) The time elapsed will be shown on the LCD display.

3. Press the 'Movie shutter button' again to stop recording (Two beeping sounds). The length of the

video footage will show on the LCD display for 3 seconds,

after which the remaining time will be shown. (The remaining time is only an estimate).

4.Press and hold the Menu button for 2 seconds to select the desired resolution (640 x 480, 320 x 240, 160 x 120). Press the Menu button again to shift through the icons representing these resolutions (at the top of the LCD display), as described on page 15. The icons will flash until you press Enter to confirm your selection.

Note:

1.Default resolution is 640 x 480 (VGA).

2.When the time is shown, you will see 'H' for hour, 'M' for minute, and 'S' for second.

3.If the recording time is long, the video file may be separated into two files automatically.