Omega Engineering FP-5060 manual Surface Mount Instructions, Fitting Installation, Calibration

3. Surface Mount Instructions

1

Mounting surface

2Remove sensor then use correct screws for panel material.

#6 or M3 metric screws recommended

120°

Mounting surface (top),	Mounting surface (side)
68 mm (2.68 in.) bolt circle

4. Fitting Installation

CAUTION:

• Maximum pipe fi tting torque: 10 ft - lbs (13 N m).

• DO NOT overtighten. Failure to observe torque specifi cation may permanently damage sensor ports.

Pipe Pipe fitting FP-5060 Pipe fitting Pipe

Sealant

Technical Notes:

•Compatible fi ttings (customer supplied): Female union (shown), reducer, or hose barb type.

•Always apply thread sealant to sensor port threads to prevent leakage.

5. Calibration

The K-Factors listed below represent the number of pulses the sensor will generate for each engineering unit of fl uid which passes. They are listed in U.S. gallons, liters and mL by sensor model:

Sensor	PULSES PER	PULSES PER	PULSES PER
Model	U.S. GAL	LITER	mL
FP-5061	9950	2629	2.629
FP-5062	9950	2629	2.629
FP-5063	3160	834.9	0.835
FP-5064	3160	834.9	0.835

page 4 OMEGA FP-5060 Series Micro Flow Sensor