Omega Engineering FP-5060 manual Instrument Wiring, Series Sensor, Recommended Sensor Position

OMEGA FP-5060 Series Micro-Flow Sensors

SAFETY INSTRUCTIONS

1.Do not remove from pressurized lines.

2.Do not exceed maximum temperature/pressure specifi cations.

3. Do not install/service without following installation instructions (see sensor manual).

4.Wear safety goggles and faceshield during installation/service.

5.Do not alter product construction.

6.Failure to follow safety instructions could result in severe personal injury!

1. Instrument Wiring

OMEGA FP-5060

Series Sensor

OMEGA FP-90 Series, FPM-5500,

FPM-9020A

Black (5 to 24 VDC)	Blk
Red (Signal out)	Power
	Red
Shield (DC return)	Freq. input
	Shld
	Gnd

			Other
Black			Instrument
		+	5 to 24
Shield	10 kΩ	-	VDC
		Gnd.	Other
Red		Input	instrument

Note: A 10 kΩ pull-up resistor is required as shown, if not provided internal to the instrument. Contact OMEGA Technical Support for assistance.

Technical Notes:

•Use 2-conductor twisted-pair shielded cable for cable splices up to 300 m (1000 ft) max.

•Maintain cable shield through cable splice.

•Route sensor cable away from AC power lines.

•AUX power required when used with any OMEGA FP90 Series Flow Transmitter.

2. Recommended Sensor Position

0°

30° 30°

	Recommended	Vertical mounting
	mounting angles	not recommended
Technical Notes:
•	Horizontal surface mount (±30 °) recommended for optimum performance.
•	Suitable for clean fl uids only. Suspended solids will cause mechanical failure.
•	¼ in. NPT or ISO 7/1 - R¼ (male) port connections

• NEMA 4X/IP65 splashproof enclosure

OMEGA FP-5060 Series Micro Flow Sensor page 3