Emerson CF730 warranty Installation of Wall Control, SINGLE-POLE Installation

2. At all wall box locations remove faceplates and screws from existing controls. Pull controls out from wall boxes and determine which wall box contains the “hot” lead and which wall box contains the “load” wire. Also, identify traveler wires which are common to both wall boxes. Disconnect wires from existing controls only. Do not attempt to disconnect any wires not already connected to existing controls.

Figure 16

3-WAY INSTALLATION

(On fan controlled by two different wall controls) (See Figures 17 and 18.)

1. Disconnect power at circuit breaker or remove fuse.

BP7315 Florissant 3/7/06 8:42 AM Page 10

Installation of Wall

Control

SINGLE-POLE INSTALLATION

(Figure 15)

HOT	BLK	FAN/LIGHT
		WALL CONTROL
	EMERSON	BLACK
		BLACK	LOAD
NEUTRAL			GROUND
REMOTE CONTROL
RECEIVER LOCATED
UNDER THE FAN
HOUSING

HI
	LIGHT
MED
LOW
FAN OFF
EMERSON		®
OFF	ON

BLK	T			HOT
	O
	1	2	0V			O		E
			AC		S		C
						UR

T
BLACK	O LOAD
			D
			N
			U
	G	R	O
FAN/LIGHT
			WALL
WALL
CONTROL			BOX

Figure 15

1. Disconnect power at circuit breaker or remove fuse.

2. Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from control. Do not attempt to disconnect any wires not already connected to existing control.

3. Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position. 3.

!WARNING

Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

4.	Connect one black wire of wall control
	to the “hot” wire. Securely connect
	wires with wire connectors supplied
	(Figure 16).
5.	Connect one black wire of wall switch
	to the “load” (black) wire in wall box.
	Securely connect wires with wire
	connector supplied.
6.	Screw wall control into wall box and
	install decorator style	faceplate
	(included). Leave wall control in “OFF”
	mode until fan installation is completed.
7.	Refer to page 4 and complete the
	ceiling fan installation.	10

!WARNING

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

4.Install a wall control in the wall box containing the “hot” wire first. Connect the black wire of the wall control to the “hot” wire. Securely connect wires with wire connectors supplied.

5.Connect one black wire of the wall control to both remaining traveler wires in the wall box and secure with wire connector supplied.