BP7315 Florissant 3/7/06 8:42 AM Page 12
Operating Your
Ceiling Fan
IMPORTANT
5. To turn the housing lights on and off, press and release the LIGHT button. The light will turn on at the light level previously set (see step 4).
Fan installation must be completed, 
including the installation of the fan blades, before testing of the remote control.
Your Fan/Light Wall Control (Figure 19) has full control of your fan and light. However, airflow direction is controlled by a pull chain on the light fitter switch.
1. Restore electrical power to the outlet box by turning the electricity on at the service panel.
NOTE: Make sure that the ON/OFF slide switch on the Fan/Light Wall Control is in the ON position.
2. To set the desired fan speed, press the HI, MED, or LOW buttons to operate your fan on high, medium, or low speed (Figure 19).
3. To turn your fan off, press the OFF button.
4. To set the level of housing light brightness, press and hold the LIGHT button. The light brightness will continue to increase then decrease while the button is held down. When the light is at the desired brightness, release the button.
6.If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Turn the lower glass counterclockwise and remove the glass from the light fitter (Figure 12). Remove the pull chain from the clip on the light fitter and pull on the pendant until the reversing switch clicks. Replace the pull chain in the clip, then replace the lower glass on the light fitter, and turn the glass clockwise until the glass stops turning. Turn the fan on again; the blades will turn in the opposite direction and reverse the airflow.
HI
LIGHT
MED
LOW
FAN OFF
EMERSON®
OFF |
|
| ON |
Figure 19
12