Models: PMD8137
PMD8142
PMD8143
Recommended size of Extension Cord for Battery Charger
Length of Cord (Feet) | 25 | 50 | 100 | 150 |
|
|
|
|
|
AWG Size of Cord* | 18 | 18 | 16 | 14 |
Owner’s Manual
Controls and Components:
Battery and AC Charger
1.Battery with Release Buttons On Each Side (PMD8137 comes with 2 batteries)
2.1 Hour “Quick Charge” Charging Stand with LED Charging Indicators
*The smaller the AWG (American Wire Gauge) number of the extension cord, the higher the capacity of the cable for conducting current to ensure proper usage of the tool.
7.Do not operate charger with a damaged cord or plug.
8.Do not operate the charger if it has received a sharp blow, been dropped or damaged in any other way.
9.Do not open the drill, battery or battery charger.There are no user serviceable parts. Opening the unit will void the warranty.
10.Unplug the charger from its power source when not in use.
11.Do not touch the terminals inside the battery charger with any other metal object such as nails or coins.This can short the charger.
12.Do not store the unit in areas where the temperature can exceed 120°F.
13.Do not throw the battery or battery charger in fire.This can cause an explosion.
14.WARINING: Batteries vent hydrogen gas and may explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of an open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately for a minimum of 10 minutes and seek medical attention.
15.During extreme conditions, the battery may leak. This does not indicate a battery failure. However, if the liquid gets on your skin, immediately wash with soap and water, neutralize the area with a mild acid such as lemon juice or vinegar. If the liquid gets into your eyes, flush them with clean water immediately for a minimum of 10 minutes and seek medical attention.
Drill:
3.3/8” Jacobs Keyless Chuck
4.24 AdjustableTorque Settings Control Ring
5.Forward/Lock/Reverse Switch
6.High/Low Speed Switch
7.Variable SpeedTrigger Switch
8.Accessory/Bit Holder
9.RUBBERSUIT™
(entire drill body is covered with smooth rubberized paint)
Accessories:
10.6 Various Screwdriver Bits
11.2” Extension Bar
12.2 Double Ended Screwdriver Bits
13. 6 Various Drill Bits |
| 6 | 9 |
| 5 | ||
|
|
|
4 |
|
| |
3 |
|
|
|
8 |
| 7 | |
|
| ||
1 |
|
| |
13 |
|
|
|
|
|
| |
11 | 12 | ||
|
|
| |
INSTRUCTIONS FOR USE: |
| ||
Charging The Battery |
|
1
2
10
THE BATTERY(IES) MAY NOT BE FULLY CHARGED FROM THE FACTORY. READ ALL INSTRUCTIONS THOROUGHLY PRIOR TO FIRST USE.
The Drills covered by this manual use the same battery and battery charger.
Your Drill comes complete with a rechargeable battery, which we recommend that you fully charge before the first use.
Drill must be charged for 1 hour prior to first use. After initial charge, allow approximately 1 hour to recharge your battery.
3 | 4 |