Message Codes
If the message Error does not disappear after switching on the device repeatedly, contact the dealer.
If the message InFo appears with a number, press the Clear button and observe the following instructions:
No. | Cause | Correction |
204 | Calculation error | Perform measurement |
|
| again. |
|
|
|
240 | Data transfer error | Repeat procedure. |
|
|
|
252 | Temperature too high | Let device cool down. |
|
|
|
253 | Temperature too low | Warm device up. |
|
|
|
254 | Battery voltage too low | Change batteries. |
| for measurements |
|
|
|
|
255 | Received signal too | Change target surface |
| weak, measuring time | (e.g. white paper). |
| too long |
|
|
|
|
256 | Received signal too high | Change target surface |
|
| (e.g. white paper). |
|
|
|
257 | Too much background | Shadow target area. |
| light |
|
|
|
|
258 | Measurement outside of | Correct range. |
| measuring range |
|
|
|
|
260 | Laser beam interrupted | Repeat measurement. |
|
|
|
Care
•Clean the device with a damp, soft cloth.
•Never immerse the device in water.
•Never use aggressive cleaning agents or solvents.
Disposal
CAUTION
Flat batteries must not be disposed of with household waste. Care for the environment and take them to the collection points provided in accordance with national or local regulations.
The product must not be disposed with household waste.
Dispose of the product appropriately in accordance with the national regu- lations in force in your country.
Adhere to the national and country specific regulations.
Product specific treatment and waste management can be downloaded from our homepage.
WarrantyEN
Lifetime Manufacturer's Warranty
Warranty coverage for the entire usage time of the product according to Leica Geosys- tems International Limited Warranty. Free of charge repair or replacement for all products that suffer defects as a result of faults in mate- rials or manufacturing, for the entire life of the product.
3 Years no Cost
Guaranteed service should the product become defective and require servicing under normal conditions of use, as described in the user manual, at no additional charge.
To receive the "3 years no cost" period, the product must be registered at www.leica- geosystems.com/registration within 8 weeks of the purchase date. If the product is not registered, a "2 years no cost" period applies.
Leica DISTOTM E7100i 812795a | 8 |
|
|