Leveling Base
The optional leveling base makes it easy to level the GPL3T across its length and its width.
1.Orient the laser tool such that laser end is at the narrow end of the base.
2.Please the laser tool on the base such that it sits between the alignment ridges and that its threaded mount sits over the stud at the center of the base.
3.Level the laser tool lengthwise by rotating the knob nearest to the laser aperture until the bubble is between the two lines on the spirit level.
4.Level the laser tool widthwise by rotating the knob that is furthest away from the laser aperture until the bubble is between the two lines on the spirit level.
Operating Instructions
Introduction:
Congratulations! You have just purchased a
Turning GPL3T on and off:
To turn laser tool on, turn the knob on the back of the unit clockwise.
To turn laser tool off, turn the knob counter clockwise to the original position.
On/Off |
Leveling GPL3T:
The laser tool has three 90˚ beams that can be used to level, plumb and square.
When the laser tool is in the horizontal orientation the bubble in the bubble vial in the middle of the unit must be centered.
When laser tool is in the vertical orientation the bubble in the bubble vial closest to the beams must
be centered.