RULES FOR SAFE OPERATION (Continued)
SUPPORT LARGE PANELS. To minimize the risk of blade pinching and kickback, always support large panels as shown in figure 9, page
10.When cutting operation requires the resting of the saw on the workpiece, the saw should be
rested on the larger portion and the smaller piece cut off.
•LOWER BLADE GUARD.
_k WARNING: If lower blade guard must be raised to make a cut, always raise it with the retracting
handle to avoid serious injury. See Figure 20, Page 15.
•GUARD AGAINST KICKBACK. Kickback occurs when the saw stalls rapidly and is driven back towards the operator. Release switch immedi- ately if blade binds or saw stalls. Don'tremove saw from work during a cut while the blade is moving. See Pages 9 and 10.
•BEFORE MAKING A CUT, BE SURE THE DEPTH AND BEVEL ADJUSTMENTS ARE TIGHT.
USE ONLY CORRECT BLADES. Do not use blades with incorrect size holes. Never use blade washers or bolts that are defective or incorrect.
The maximum blade capacity of your saw is
AVOID CUTTING NAILS. Inspect for and remove all nails from lumber before cutting.
NEVER touch the blade or other moving parts during use.
NEVER start a tool when its rotating component is in contact with the workpiece.
NEVER lay a tool down before its moving parts have come to a complete stop.
DO NOT operate this tool while under the influence of drugs, alcohol, or any medication.
POLARIZED PLUGS. To reduce the risk of electric shock, this tool has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
•WHEN SERVICING USE ONLY IDENTICAL CRAFTSMAN REPLACEMENT PARTS.
•SAVE THESE INSTRUCTIONS. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instructions also.
WARNING: Some dust created by power
sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from chemically- treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
_k Look for this symbol to point out important safety precautions. It means attention!!! Your safety is involved.
,_k WARNING:
The operation of any circular saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields, available at Sears Retail Stores.
SAVE THESE INSTRUCTIONS
5