Sears 315.27516 Starting a CUT, Know the right way to use your saw, To Help Maintain Control

Page 11

STARTING A CUT

Know the right way to use your saw.

See Figure 11,

_RIGHT

Fig 11

Never use your saw as shown in figure 12.

TO HELP MAINTAIN CONTROL:

Always support your workpiece near the cut.

Support your workpiece so the cut will be on your right.

Clamp your workpiece so it will not move during the cut.

Place your workpiece with its good side down.

Note: The good side is the side on which appearance is important.

Before beginning a cut, draw a guideline along the desired line of cut. Then place front edge of base on that part of your workpiece that is solidly supported. See Figure 11.

Never place your saw on that part of the workpiece that will fall off when the cut is made. See Figure 13.

WRONG

Fig. 12

Never place your hand on the workpiece behind your saw while making a cut.

,_ WARNING: To make sawing easier and safer, always maintain proper control of your saw. Loss

of control of your saw could cause an accident resulting in possible serious injury.

WRONG

Fig. 13

Keep the cord away from cutting area. Always place the cord to prevent it from hanging up on the workpiece while making a cut.

,_ DANGER: If the cord hangs up on the workpiece during a cut, release theswitch trigger

immediately. Unplug your saw and reposition the cord to prevent it from hanging up again.

,_ DANGER: Using your saw with a damaged cord could result in serious injury or death. If the cord

has been damaged, have it replaced before using your saw again.

11

Image 11
Contents OwnersManual Sears, Roebuck and Co., Dept WA, Hoffman Estates, IL Read ALL Instructions Symbol Meaning Safety Alert SymbolKeep Work Area CLEAN. Cluttered areas Double InsulationAvoid Accidental Starting Always Wear Safety GlassesRemove Adjusting Keys Do not USE Tool if Switch does notLower Blade Guard Rules for Safe OperationCutting Depth at 0 Bevel Cut Blade ArborApplications SwitchUpper Bladeguard Spindlelockswitch Know Your Circular SAWGuardhandle Blade Outer Washer Screw To Assemble or Remove BladeTo Assemble Blade SpindleBest guard against kickback is to avoid dangerous practices SAW BladesBlade Guard System KICKBACK== Bladesettoo DeepBase Assembly Depth Adjustmentlever Depth of CUT AdjustmentTo Adjust Blade Depth CORRECTBLADEDEPTHSETTING=To Help Maintain Control Starting a CUTKnow the right way to use your saw Never use your saw as shown in figureGuide To Cross CUT or RIP CUTTOP Viewof SAW Front Right RememberLower Bladeguard Bevel Adjustment KnobTo Adjust Bevel Setting To Bevel CUTLength of CUT Scale To AdjustAdjustment Screw Positive 0 Bevel StopEdgeguideguide RIP Guidethru Holes To Pocket CUTLower \ Bladeguard Pocketcut Lowerblade Guardhandle To RIP CUT Optional RIP Guide Edge GuideExtension Cords GeneralLubrication 32in Power Cord or Switch ReplacementBlack Motor Powercord DiameterSee Note a Description Quan Key Part No. NumberAt your home or ours