Tilting Drill Head, Rotating Drill Head

Belt Tension

Butterfly Set

Screw

NOTE: When properly tensioned, V-belt should deflect about 1/2" under thumb pressure at mid-point between pulleys.

5Tighten belt tension Butterfly Set Screw and close Pulley Cover

Tilting Drill Head

The Drill head can be tilted to drill up to 45 degrees clockwise

and 90 degrees counter-clockwise of vertical To tilt Drill head, loosen Lock Handle on right side of Column head and pull out and turn plunger of Vertical Lock (REF 87) Use

Angle Gauge (REF 85) on Column head and full length scored V groove on Horizontal Tube (REF 81) to set desired angle Lock in position using Lock Handle When returning to vertical position, turn Vertical Lock plunger and allow it to snap down onto Horizontal Tube When vertical position is reached, plunger will pop into milled slot on Horizontal Tube Tighten Lock Handle to lock position

Rotating Drill Head

The Drill head can rotate 360 degrees around the Column Take care when mounting Radial Drill Press to allow suffi- cient clearance for full use of this feature. Loosen Lock Handle on left lower area of Column Head. Rotate to desired

position and lock in place with Lock Handle

Tilt Lock

Handle

Rotation Lock	Horizontal
Handle	Feed Knob

Scored

V Groove

Lock

Handle

Vedical

Lock

Moving Drill Head In or Out

The Drill head can move in or out along Horizontal Tube (REF 81) to drill large objects or move between holes without unclamping workpiece. Loosen same Lock Handle as for tilt- ing Drill head above Use Horizontal Feed Knob (REF 89) to move Drill head in or out to desired position Lock in place with Lock Handle before drilling to prevent drill bit from "walk- ing" along the wotkpiece surface