Sears 149.213340 warranty NNSTALUNG Radual Drull Press

Page 7

f

I

7Make sure bottom of Spindle Shaft (REF 42) and bore of Chuck (REF 46) are clean and free of grease Press Chuck up onto Spindle Shaft_

NOTE: To avoid damage to Chuck, rotate Chuck barrel until jaws are fully open.

8Using a mallet or a block of wood and hammer, firmly tap Chuck upward into position onto Spindle Shaft

nNSTALUNG RADUAL DRULL PRESS

WARNING: BEFORE USING RADIAL DRILL PRESS_

MAKE SURE IT IS ATTACHED TO A FIRM AND STABLE SUP-

PORT SURFACE USING CARRIAGE BOLTS AND WING NUTS PROVIDED.

12 3/4" Fore and Aft Travel

1Choose an area that allows sufficient clearance to take full advantage of the Radial Drill Press's lateral, rota- tional, and tilt motions

2Bolt Radial Drill Press to a firm and stable surface using Carriage Bolts and Wing Nuts provided, Be sure bolts pass entirely through mounting surface and are at least 5/16-18 standard strength_ Tighten all bolts and wing nuts securely

3/8" Diameter

2 Hotes

6 1/4"

Head Tilts 45"

C_ockwise and 90"360" Rotation

Counter-clockwise

Use Carriage Bolts and Wing Nuts Provided

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Serial Or Code Number Save This Manual For Future ReferenceFor Power Tools General Safety RulesKeepworkareaclean Table of Contents Safety Rules for Drill PressesTable of Loose Parts Unpackrng and Checkung ContentsAssembly NNSTALUNG Radual Drull Press Depth Stop Adjustment Controls and AdjustmentsSpindle Return Spring Adjustment Table Adjustment Spindle Speeds Belt Tension AdjustmentRotating Drill Head Tilting Drill HeadMoving Drill Head In or Out Alignment of Motor Pulley to Spindle Pulley Adjusting Spindle Perpendicular to TableDrilling Metal MaintenanceCorrect Drilling Speeds Drilling WoodMortising Kit AccessoruesVises and Clamps REPAnR Parts Description QTY Parts ListBnch Radbal Drill Press
Top Page Image Contents