CONTROLS AND ADJUSTMENTS
AND POWER CORD IS UNPLUGGED BEFORE PERFORMING
_ WARNING: MAKE SURESWITCHIS IN OFF POSmON
CHECKS= ADJUSTMENTS I OR SETUP PROCEDURES,
2.Table Rotation - To rotate table, first loosen Lock Handle. The table can be rotated from side to side or completely out from under Spindle Shaft to allow work surface on base to support workpiece_
On-Off Switch
The
and has operating positions clearly marked_ Push switch up to turn tool ON and down to turn it OFF. The switch has a
Switch Key (REF 60) that, when removed, allows switch to be locked in OFF position. To activate locking feature, push switch to OFF and pull Switch Key out of switch.
Switch Key | Switch |
Depth Stop Adjustment
When it is desirable to drill holes to an exact depth, the built- in depth stop can be set
1With Radial Drill Press turned OFF, adjust table height until driUbit barely touches workpiece at spot to be drilled, and lock into position
2.Loosen Depth Stop Butterfly Set Screw (REF 36) and rotate Depth Gauge Assembly (REF 35) until desired drill depth on Scale aligns with Pointer on Spindle Housing (REF 25). Tighten Butterfly Set Screw_
Butterfly Set Screw
Depth Scale | Depth Scale |
Pointer |
|
Spindle Return Spring Adjustment
Table Adjustment
1_ Table Height - To raise or lower Table, loosen Lock Handle on back of Table BrackeL Crank Lift Handle to raise or lower Table, then lock position with Lock Handle
An automatic spindle Return Spring (REF 28) is installed in Drill Head to return spindle to full up position. This spring was preset at the factory and should not be readjusted
unless absolutely necessary. Adjust Return Spring as fol- lows:
1Loosen two Nuts (REF 29 & 30) on side of Spring Assembly (REF 28) about 1/4" NOTE: Do not remove these nuts from Feed Shaft (REF 34).
2Hold Spring Assembly firmly and pull it out away from side of Drill Head Rotate Spring Assembly until next notctl engages with cast tab on side of Drill head.
8