Miller Electric Invision 456MP manual Synergic Controls and Overview, Example

4-4. Synergic Controls and Overview

3

2

1

4

Example

To select Program 7, set to Non Adaptive, and set Arc Length to 36, proceed as follows:

Select top line by pressing	> P	r	g		7	0	3	5 A l	4 0 4 3	A r
Select push button until > is
on top line. Press Increment
button until Program 7 ap-	A	d	a	p	t	i v	e
pears.

Controls

1Display

2Parameter Select Push Button

Press button to move > on display. The parameter indicated by > is selected.

3 Increment Push Button

Press increment button to increase selected parameter.

4 Decrement Push Button

Press decrement button to decrease selected parameter.

See example at left.

Overview

The built-in synergic control pro- vides four modes of operation:

Manual Pulse MIG − control func- tions as a discrete pulsed MIG CC control.

Mig − control functions as a remote voltage control.

Stick − unit is placed in CC mode for SMAW welding.

Synergic Pulser − programs that use factory-entered values are used to control process.

Setup screens (see Section 4-6) al- low programs or modes to be made inaccessible (locked out) to the op- erator, and the language used in the displays (English, French, etc.) to be defined.

Press Select push button to select second line, and press Increment or Decrement but- ton so Non Adaptive appears.

Turn Output Adjust control to set arc length to 36.

P	r	g	7 0	3	5 A l 4 0 4 3 A r
> N o n			A d a	p	t i v e

36

OM-193 267 Page 22