Threaded

BP7384 Camden, CF3600 2/18/09 2:57 PM Page 10

	BLACK AND BLUE
GROUND	FAN WIRES
WIRE
LISTED	WHITE SUPPLY
WIRE	WHITE SUPPLY
CONNECTOR (3)	(NEUTRAL)
GREEN WIRE
(GROUND) FROM	WHITE FAN
HANGER BRACKET	WIRE

GREEN WIRE	BLACK SUPPLY
(GROUND) FROM	(HOT)
HANGER BALL
	NOTE: CEILING COVER
	OMITTED FOR CLARITY.

Figure 12

! WARNING

Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.

1-1/4"
THREADED
STUD (2)
#8 EXTERNAL	CEILING
TOOTH	COVER
LOCKWASHER (2)	#8-32 KNURLED
	KNOB (2)

Figure 13

! WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

3. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 12).

4. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 13).

5. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 13). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.

6. Cut the 3-speed switch pull chain to a desired length (optional). Connect the wood pendant (supplied) to the 3- speed switch pull chain by sliding the wooden pendant (small hole first) onto the pull chain. Attach the chain coupler to the end of the chain and allow the wooden pendant to fall down over the coupling.

10	Model No.: CF3600