Emerson CF3600ORH, CF3600AP owner manual Materials, Unpacking Instructions

BP7384 Camden, CF3600 2/18/09 2:57 PM Page 3

THIS FAN IS SUITABLE FOR DAMP LOCATIONS

SUCH AS COVERED PORCHES, COVERED PATIOS, AND COVERED

DECKS...ANYWHERE THERE IS A ROOF OVERHEAD.

This Manual is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver

One wire stripper

One stepladder

Materials

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire shall be a 3-conductor (2-wire with ground) of the following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (Page 9). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1. Open carton containing fan. Remove top half of styrofoam unit. Remove parts, placing all carton contents on a soft protective surface to prevent scratching the painted or plated finishes, and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One motor cover

c.One coupling cover

d.One ceiling cover

e.Four blade flanges

f.Four blade medallions

g.One switch cover plate

h.One hanger bracket

i.One hanger ball/downrod assembly

j.One loose parts bag containing:

1.One clevis pin

2.One hairpin clip

3.Two #8-32 x 1-1/4” threaded studs

4.Two #8 external tooth lockwashers

5.Two #8-32 knurled knobs

6.Thirteen #10-32 x 3/4” oval head blade screws

7.Five wire connectors

8.One 3/16” hex wrench

9.One chain coupler

10.One chain pendant

11.Nine #8-32 x 5/8” flat head flange screw

12.One 5/16-18 x 1/4” setscrew

13.Three #8-32 x 1/4” flat head screws

14.One pendant

3 Model No.: CF3600