Sears 200.71460 Before Using Your Battery Charger, Assembling your charger, Parts Tools Needed

Page 5

Before Using Your Battery Charger

It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery.

Assembling your charger

It is important to fully assemble your charger before use. Follow these instructions for easy assembly.

PARTS:

TOOLS NEEDED:

Two 10-32thread cutting

3/8" wrench

screws

(for mounting foot)

Two 1/4-20 thread cutting

5/16" wrench

screws

(for wheels)

Two wheels

Hammer

One axle

Phillips screwdriver

Two axle caps

 

Two axle brackets

 

One handle

 

One mounting foot

 

To attach the axle assembly:

1.Remove charger from packing materials and place on its side on a flat surface. Attach mounting foot and secure with the two 1/4-20 thread cutting screws.

2.Hold axle upright on floor or work surface. Then, using a hammer, tap one of the plastic hubs onto

the top end

of the axle. Be sure to tap the hub on

a-

straight. Slide both wheels onto the axle with the

 

hubs facing

inward.

 

continued on next page

4

Image 5
Contents Model No SEA/RSContents Help us help you Important Safety InstructionsPersonal Safety Precautions Parts Wiring diagramParts Tools Needed Before Using Your Battery ChargerAssembling your charger Electrical Shock Hazard Plugging itTo attach the handle Length of Cord, In Feet Using an extension cordPreparing your battery to be charged Hold feature Using Your Battery ChargerSetting the controls Good BAD Charging Weak System OCharging your battery in the vehicle Charging Your BatteryNormally the ONE That is Grounded Negative Grounded SystemCharging your battery outside the vehicle AMP 20AMP 60AMP Chart MethodHydrometer or Electronic Method Maintenance and care Using the engine start featureProblem Possible Cause SOLUTION/REASONS TroubleshootingModel No SEAR8