Dixon ZTR 5424, ZTR 5020 manual Specifications, Model ZTR

CHASSIS:

BODY:

SEAT:

MOWER DECK:

BLADE DRIVE: DRIVE SYSTEM:

ENGINE:

STARTING SYSTEM:

TIRES:

RECOMMENDED TIRE PRESSURE:

CAPACITIES:

DIMENSIONS:

NOTE:

SPECIFICATIONS

Model ZTR 5424

11 GA - rectangular tube

Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.

Designed for operator comfort by use of high density closed cell foam padded back and arm rests, upholstered with Cordura™ water-repellent fabric. Seat is adjustable fore and aft.

1 3 GA stamped steel construction 3 blades combine for a 42" cut width Cut height approximately 1 .5" to 4.5" via 7 position lift handle

Electric clutch

Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear gearbox.

17HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, dual element air cleaner, impulse fuel pump

Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.

Front	11 X 4 X 5 smooth profile
Rear	18 X 9.5 X 8 Multi Trac CS
Front	16-21 Ibs. Rear	8- 14 Ibs.
,

\'

Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank - 3 quart with in-line 10 micron filter Hydrostat oil recommendation, refer to page 37 Engine - 2 qts. SAE 30 (with filter)

Width	54"
Height	45"
Length	72"
Weight	61 5 Ibs.

Additional information provided in service instructions underthe individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 9