CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE: DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 10
SPECIFICATIONS
Model ZTR 5020
11 GA - rectangular tube
Two piece - made of rotational molded polyethylene. Front body contains access panels for battery service and engine to mower deck belt removal. Rear body tilts up to allow service on the entire drive system.
Designed for operator comfort by use of high density closed cell foam padded back rest and arm rests, upholstered with Cordura™
3 Decks are available. 42" & 60" are made of stamped steel. 50" is made of 1 1 GA fabricated welded construction with external reinforcement ribs 3 blades combine for either a 42", 50", or 60" cut width Cut height approximately 1 .5" to 4.5" via 8 position lift handle
Electric clutch
Each rear wheel is independently driven by a HydroGear
20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full pressure lube system, dual element air cleaner, integral fuel pump.
Electric by key switch operation with safety interlocks on parking brake and blade drive clutch.
Front | 11 X 4 X 5 smooth profile | |
Rear | 20 X 1 0.5 X 8 Multi Trac | |
Front | Ibs. | |
Rear | 8- 14 | Ibs. |
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with
Hydrostat oil recommendation, refer to page 37, Engine - 2 qts. SAE 30 (with filter)
Width | 54"(42" Deck), 60"(50" Deck), 73"(60"Deck) |
Height | 45" |
Length | 72" |
Weight | 630 lbs.(42" Deck), 668 Ibs. (50" Deck), 685 Ibs. (60" Deck) |
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE