Dixon ZTR 5424 Care And Maintenance, Mower Deck Installation, Position mower deck under chassis

Models: ZTR 5424 ZTR 5020

1 48
Download 48 pages 28.41 Kb
Page 33
Image 33
3.Position mower deck under chassis.

CARE AND MAINTENANCE

MOWER DECK INSTALLATION:

1.Loosen and remove front body mounting bolts (P/N 3368) and washers (P/N 3066). Disconnect headlight wiring plug from wiring harness. Lift front body from chassis.

2.Install rear hanger rods on lift frame. Slide lift plate on hanger rods, small holes in lift plate will face rear of mower, and start nylok nuts on each hanger rod until approximately 1/2 inch of threads are exposed.

3.Position mower deck under chassis.

4.Raise front of mower deck and slide front support rod through lift frame and tabs on mower deck. Install hair pin clips on front and rear of support rods.

5.Move lift lever to lowest cut position, install engine to mower deck drive belt on top center pulley. Check belt routing after installation to make certain that belt is centered in groove of electric clutch pulley.

6.Move lift lever toward high cut position and remove brake link from hole on lift lever.

7.Install front body, connect headlight wiring.

Page 31

Page 33
Image 33
Dixon ZTR 5424, ZTR 5020 manual Care And Maintenance, Mower Deck Installation, Position mower deck under chassis