Emerson KF240PRZ00 owner manual Previously removed Figure

BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 7

LIGHT FITTER

ASSEMBLY

REMOVE AND RETAIN THREE PAN HEAD SCREW/LOCKWASHERS

Figure 4

LIGHT FITTER CONNECTOR

MOTOR

CONNECTOR

10. Position the top and bottom halves of the styrofoam packaging side-by-side on the floor with a six to eight inch gap between the halves (Figure 6). Carefully place the partially assembl- ed ceiling fan on the styrofoam halves, with the light fitter assembly positioned in the gap and the fan assembly resting on the fan blade assemblies.

PARTIALLY

ASSEMBLED FAN

8. Remove and retain the three outer screw/lockwashers from the light fitter adapter (Figure 4).

9. Position the light fitter assembly on the		6 TO
light fitter adapter. Line up the three		8-INCH
		GAP
holes on the light fitter with the
threaded holes in the adapter and
reinstall three screw/lockwashers		STYROFOAM PACKAGING
(previously removed) (Figure 5).	Figure 6

CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the light fitter and the light fitter adapter.

REINSTALL THREE
PAN HEAD SCREW/	LIGHT FITTER
LOCKWASHERS
	ASSEMBLY

11. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 7). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 16.

LIGHT FITTER ADAPTER

PIN

HANGER

BALL

DOWNROD

SETSCREW

Figure 7

Figure 5

NOTE: If you have an eight-foot ceiling, you will have to use the 8” downrod (supplied) in order to maintain the necessary blade-to-floor clearance of seven feet.

7