Emerson KF240PRZ00 owner manual How to Hang Your Ceiling Fan

Page 9

BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 9

!WARNING

It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.

16. Place the ceiling cover over the downrod. Then reinstall the hanger ball (Figure 10) on the downrod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.

PIN

HANGER

BALL

DOWNROD

SETSCREW

How to Hang

Your Ceiling Fan

!WARNING

The fan must be hung with at least 7' of clearance from floor to blades (Figure 11).

CEILING

AT LEAST

7'

FLOOR

Figure 11

!WARNING

The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.

CEILING

COVER

Figure 10

17.The fan comes with blue, black and white leads that are 80” long. Before installing the fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2” from end of leads.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

18. You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.

1. Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 12).

9

Image 9
Contents Lorraine Safety Instructions Additional Safety Instructions for InstallationDate Code Unpacking Instructions MaterialsEmerson Electrical Requirements Ceiling Fan Procedures How to Assemble Your Ceiling FanGeneral FAN Blade Previously removed Figure Using the hex wrench supplied How to Hang Your Ceiling Fan Outlet BOX TWO Screws Supplied With Stud How to Wire Your Ceiling FanYour ceiling fan is now installed Setting Operating Frequency of Wall Control and Receiver Installation of Wall ControlDo not connect any neutral white Required WAY WIRlNG Diagram NEW ConstructionOperating Your Ceiling Fan Switch on the Fan/Light Wall Control is in the on positionMaintenanceAccessories Important Care InstructionsFor your Ceiling Fan Trouble Probable Cause Suggested Remedy Trouble ShootingHOW to Order Repair Parts Repair PartsKey Part Numbers Model No Description Repair Parts ListingWhat The Warranty Covers Limited Warranty