Sanding, Helpful Hints | Sears 113.29003 instruction

Figure 25

Figure 36

BOiUNG

Your saw can also be €onveded 1o a horZzonta drill for boring by using one of the recommended c_ucks ahd the

proper drill For drilling holes on an angle the radial arm d_ould be positioned to the desired angle while the work is

parallel to the fence, See Figure34.

SANDING

Using the 10" sanding disc mounted on the saw end of the motor, you can convert your saw into a sander which can be operated in any position° The loose collars should be used on both sides of the sanding disc°

STABILIZING WASHERS FOR THIN bLADES

Stabilizlng washers should be used with thin btades for improved appearance of the finish cuts.

HELPFUL HINTS

1_ The life of the laminated saw table can be greatly length- ened if a 1¼,, piece of plywood istacked to the table top after leveling Then all cutting can be done in the added plebe of plywood instead of the laminated table.

_. There is a posslbility that during or after shipment, the wooden front tabe; spacer board, or rear table might

became slightly warped Lay a straight edge across the surface of the table and check for gaps or high spots on the table. Any portions of the table which are not fiat should be planed and sanded until flat Sanding can be done by using one of the two key chucks referred to under "'Routing"and a Craftsman moulded rubber 7" sanding disc_

2.When sanding the table top (See Figure 35) oI" routing with the work stationary, the arm lock pln can be pre- vented from automotlcally indexing at 0 ° and 45 ° by

rotating the arm latch handle about 6 turns counter- clockwise from the locked position_

4.A scale may be attached to the fence to aid the oper- at'orwhen measuring lengths during cToss-cutoperations.

This can be accomplished by ta_ing a yard stick to the fence as shown° See Figure 36_

S. In the event that the fence is warped and cannot be straightened by tightening the table clamps proceed as follows: Remove the fence and replace with a temporary fence made from a straight piece of scrap lumber_ Pro- ceed to cut slot_ in the original fence where the gap between the fence and front table was determined to be

the greatest_ See Figure 37 for slotting.

Replace the fence, after slotting, behind the front table with the dots toward the rear and tighten the tabte

damps_

6.There are three positions in which the fence can be located. See Figure 38.

I. Normal position.

2.Position used for maximum cross-cut an 1" material and for greater bevel and miter capacity°

CAUTION

Rip scales cannot be used in this F_>sltlon. 3_ Position used for maximum out-Hp capQcff',/.

7.An auxiliary table top for molding or shaping can be constructed slmffar to Figure 39_ Note the shape of the

back guide fence against which your work p_eceis moved° A cut-out 5" wide should be made at the center of this

guide fence to give adequate clearance for the molding head and cutters. Also a wider clearance marked "'A°' should be made to allow for the radial saw motor. Be

sure the front edge of the auxiliary table is parallel with the surface of the guide fence. With the auxiliary table top thus completed it is ready for use by merely damp- lng it into position with "C °'clamps.

2_4	--I,._A °_ LONG
EDGES rA_LALLEL	I	I
		!	lAD IAL SAW
			TABLE

Figure 37

_,_