_OUHTING THE SAW TO A WORK BENCH
The saw should be placed on a _itoble sturdy work bench and posltlor,ed so that the elevation crank (figure B) is flee to i'otate_The ba_ of the saw must be mounted to a flat
•.urfoce on the work bench to prevent distortion of the saw ase_The nuts, screws,and washers which attach the wooden
_ipping skids to the saw base may be reed to secure the saw base to the work bench. Check that saw is level or
sloped slightly to the rear so that carriage when undamped, does not run ffwe]y to the front end of the radial arm.
INSTALLATION OF THE TABLE AND FENCE
1.Turn elevation crank to robe motor clear of shipping brackets_
2.Remove shipping brackets from base.
3o Place front table on channels with notch in table for- ward and down as shown in Figure 8o
4_ Align holes in front table with three forward mount- ing holes in channels_ See Figure 8.
5o Assemble six machine screws and washers through six
holes as shown_
6_ Attach six lockwashers and nuts. Before tightening nuts
securely push table evenly toward rear of saw_ Tighten nuts.
7, Lay fence in vertical position behind front table. B Lay table _oacer board behind fence.
9_ Lay rear table with
spacer board.
10.lnstaff table damps as shown and tighten securely against edge of rear table.
ADJUSTING THE TABLE PARALLEL TO THE
RADIAL ARM
1o Remove saw guard with holding washer and wing nut. 2_ Remove shaft nut and one loose collar on motor shaft°
See Figure 11.
. Insert arbor wrench between collars on motor shaft.
Figure 9. Tighten shaft nut by hand.
4.Tighten radial arm handle (item 12, figure 5)_
5_ Loosen carriage lock knob (item 7, figure 5) and turn elevation crank until end of arbor wrench just touches
the tobte top thus permitting the wrench to be swung back and forth_ See Position 1, Figure 9. Mark this spot
and Positions 2, 3 and 4 with a pencil.
NOTE
Do not turn the elevation crank throughout the re- mainder of this procedure as the radial arm must remain at the same height above the table while checking at Positions 1, 2, 3 and 4 of Figure 9,
POSITION
1
POSITION
2
POSITION
3
POSITION
4
Figure 9
6.Pull motor to Position 2. Wrench when moved back and forth should just contact table tap as in step 4.
7.Turn arm latch handle (item 12, figure 5) counterclock-
wise and pull out. Move arm to Position 3 of Figure 9. Tighten radial arm handle and repeat procedure of step 6.
ft. Move radial arm to Pasltlon 4 of Figure 9, tighlen radio arm handle and repeat above procedure.
If contact between the wrench and the table top is not the same at all four positions the table can be leveled as fol-
lows: (See Figure 10)o
31