Sears 113.24907 manual Assembly, Into

Page 7

assembly

7, The Front Charmer should be slightly lower than the top of the Vertical Channels. Check the height with a

combination square as shown. If it is higher, loosen the Flange Nuts and lower it.

1. Screw	a 1-3/4 inch tong socket head screw tightly	into	/
each	Knob as shown.

SET SCREW WRENCH

DOTS

2.Screw a Square Nut onto each of the Follower Pins. NOTE: The Nut has four clots on one side., .they must face the threaded end.

Image 7

Contents Prinedi US ISearsKeep Work Area Clean Full ONE Year Warranty on Craftsman COPY-CRAFTERKnow Your Power Tool Remove Adjusting Keys and WrenchesIIP Never Stand on ToolCheck Damaged Parts Never Leave Tool Running UN AttendedToolsneeded ContentsBED Assembly AssemblyAppr0ximateiy Inches from Mounting COPY-CRAFTER BED to Lathe BenchBe sure to unscrew the Threaded Slide and remove it Into AssemblyCutting Tliel €nteriine Latle see Nut t0 the p0irit of the spur Center as shownAssembgy BED Plate Center ScrewFront Channel BED PLATE...supports the tool holder or the Lathe ControlComfortable CuttingUnderneath Both Channels Sharpening Making Practice Cuts Handle Sound BlockGavel Head Page Inches ThisFoot CUts t6 HandsOhtii YOU get the feel Cutt ng Making the Sound Block OperationOperaUon Duplicating a Spindle from AN Existing ONE OperationBracket to tbe right-hand BraCket With the Camp P ate Align Operation Repair parts Repair parts QTY List of Parts in Loose Parts BagsPage EL O