assembgy
C, Remove protective coat{ng from the tip of the Cutting Tool and place it in the Cradle,
d. Insert the Cutting Too} and Cradle into the Too] Post and rotate it back and forth whi}e turning the Set Screw in the top of the Too_ Post. The Set Screw should seat into cove hq the top of the Cutting Tool.
e. Hold Al;gnment Gauge tightly against Follower Pin
...make sure it is resting on top of Square Nut.
f, Push Cutting Tool gen_zly against Gauge making sure that it touches beth inside surfaces of Gauge by
rotating Too] Post.
This wifl align the tip of the Cutt;ng Tool with the Fotlower Pin,
g. WhiJe still holding Gauge firmly against Follower Pin, raise Tool Post until tip of Cutting Tool is even
with scratch mark on Gauge. Tighten Setscrew in Tool Post Base.
h.Tighten Setscrew in top of Teo_ Post. The tip of the
Cutting Tool should now be directly above the
Follower Pin as high as the eenterline of the lathe,
,.,LL | L_ | , .. | ' I, |
CRADLE
CUTTING TOOL
,,,, | ,H, | ,r,, | ,,,,, |
| ALIGNMENT | GAUGE | |
/
BRACKETS
Assemble the right and left Brackets using 3/4 inch long Round Head Bolts, Washers and Plain Hexagon Nuts.
Install on the bed as shown.
RIGHT
eRACKET
CLAMP