Sears 113.299131 owner manual Contents, Tools Needed

SAFETY INSTRUCTIONS TO OPERATOR

17.Adjust table inserts flush with, or slightly below, the table top.

18.For operations which do not permit the use of a spread- er, serious consideration should be given to the use of

jigs or fixtures to hold the work so the hands of the op- erator are removed a safe distance from the point of operation.

19.The use of abrasive or cut-off wheels, or wire wheels can be dangerous and is not recommended. (Abrasive or cut-off wheels are ,used to saw many different ma- terials including metals, stone, and glass.)

20.Objects can be thrown upward toward the operator by the back of the blade if proper operating procedures are not followed. ?his usually occurs when a small loose piece of wood or other object works around to the rear of the revolving blade. It can usually be avoided by re- moving all loose pieces from the table immediately after they are cut off, using a long stick of wood, and by keeping the guard and spreader in place at all times. Use extra caution when the guard assembly is removed for dadoing or molding, and replace the guard as soon as that operation is completed.

21.Never perform any operation "freehand." This term means feeding the stock into the saw blade or other

cutting tool without using the miter gauge, rip fence, taper jig, or some other device which prevents rotating or twisting of the workpiece during the operation.

22.Never turn your saw "ON" before clearing the table of all objects (tools, scraps of wood, etc.) except the workpiece and related feed or support devices for the operation planned.

23.Safety is a combination of operator common sense and alertness at all times when the saw is being used.

24.Do not cycle the motor switch on and off rapidly, as this may cause the saw blade to loosen. In the event this should ever occur, allow the saw blade to come to a complete stop and retighten the arbor nut normally, not excessively.

WARNING: Do not allow familiarity

(gained from frequent use of your saw) to

become commonplace. Always remember that a careless fraction of a second is suf-

ficient to inflict severe injury.

CONTENTS

			Page				Page
Unpacking	and	Pre-Assembly Instructions ....	4	Maintenance and		Lubrication	17
Power Supply and Motor Data			5	Proper	Operating	Procedures	18
Assembly	and	Adjustments	6	Trouble	Shooting	........................	22
Operating	Controls		16	Repair	Parts		24

Screwdriver (medium)

Screwdriver (small)

Pencil

TOOLS NEEDED

_ Square

I_ ]J (combination square,

Pliers Small steel scale

		3/8-1nch	wrench
		7/16-inch	wrench
_	_	1/2-inch	wrench
		9/16-1nch	wrench

NOTE: An arbor wrench and shaft wrench, for removing or installing the saw arbor nut, and all necessary hex-"L" wrenches are sup- plied with the saw. (Refer to the "'Loose Parts List.")