Sears 113.299131 owner manual Assembly and adiustments

assembly and adiustments

SIDE VIEW

4 3 2 1

4 /

SAW TABLESPACER GUIDE BAR

RACK

	SCREW
	/4 - 20 x	21N._
LOCKW_	SWITCH	BOX

Figure 11

(2)Attach this assembly to the center hole in the table and secure the assembly with a 1/4 inch Iockwasher and I/4-20 inch hex nut. Do not

tighten the nut until all attaching screws are in position.

(3)Place each rack in position (as shown in figure

11)and insert a 1/4-20 x 2 inch slotted round head screw through the outside hole, through the

guide bar, spacer and table extension. Secure with a 1/4 inch Iockwasher and 1/4-20 inch hex

nut. (See figure 10.)

(4)Place switch box in position (either to right hand or left hand side of saw table as desired). Attach with two 1/4-20 x 2 inch slotted round head screws through switch box mounting flange, rack, guide bar, spacer and table. Secure with two 1/4 inch Iockwashers and 1/4-20 inch hex nuts. (See figures 10 and 11.)

(5)Complete attachment of opposlte rack with two more screws, aligned with table in the same

sequence described above. Tighten all screws securely.

d.Installation of Auxiliary Fence and Extension. (See figure 12.)

NOTE: This adjustable, auxiliary fence and ex- tension was designed for use on the left-hand side of the saw (when facing the saw at oper- ator's position).

(1)Attach the table extension support (1, figure 12) to outside edge of left-hand table extension with

5

4

Figure 12

two 5/16-18 x 3/4 inch screws (5), 5/16-18 inch nuts and 5/16 inch Iockwashers in position as shown in figure 12. Do not tighten the screws fully.

(2)Slide the extension slide rod (2) through each rod support (3) and through the hole in each end

of the support (I). It will be necessary to slide these rods from under the table because of the

retaining rings.

(3)Attach the sliding extension (9) to each rod (2) with a 5/16-18 x 3/4 inch screw (5) and 5/16 inch

Iockwasher in the end of each rod. Do not tighten. This extension should be positioned as shown in figure 12.

(4)Move the end of sliding extension in. Level the sliding extension (9) with the table extension. Tighten 5/16-18x 3/4 screws (5) in the extension slide rods (2). Move sliding extension out and tighten 5/16-18 x 3/4 screws (5) attaching the support (1) to the extension. If binding is experi- enced, tap the rod supports (3) in the proper direction to relieve interference.

(5)Position an extension clamp (7) over each rod and through the mating hole in support (1). Secure each extension clamp with a wing nut (8).

(6)Attach the auxiliary fence (6) with the wing nuts (8), as shown in figure 12.

e.Adjust the Table Insert. (See figures 13 and 14.)

(1)Press down on table insertwith fingers to make sure it is properly secured in the table opening.

(2)Using a small scale or straightedge, check at