J
EXTENSION ROD
SUPPORTS
Figure 7 |
| Figure 8 |
SMALL STEEL SCALE | TABLE EXTENSfON | ,_ |
|
FENCE GUID_ BAR
RACK
SWITCH
BOX
SCREW
Figure 9
feners. (See figure 5.) Using parts from the correct loose parts bag, assemble the legs to the saw base
with the sixteen
loose in order to facilitate mounting the stiffeners. All four leg stiffeners are identical and since the distance on the sides is greater than the distance
on the ends, the leg stiffeners used on the sides should be attached at outer holes while the stiffeners at the ends should be attached at inner
holes. (See figure 6.)
(2)Assemble the four stiffeners with sixteen 1/4- 20 x 1/2 inch screws and
stiffeners are all in place, tighten all screws
securely. Install leveling feet, each with 2
(3)Place the saw in an upright position on its legs.
b.Installation of Side Extensions.
(1)Install table extensions on each side of the table with four
extension (See figure 7.) These extensions are provided with multiple holes on both sides (front and back) to make them adaptable to various
Figure 10
ii
table mountings. Position the extensions to the sides of the table so the four holes in the table
and the extensions are aligned when the table and extensions are correctly mated. An extension
rod support should be located under each end screw at
7 and 8.) Leave screws snug (not tight). Be sure to position the extension rod supports as shown in figure 8.
(2)Place a small steel scale across saw table edge and table extensions edge and, using the rubber
mallet, tap extensions slightly up or down (or forward and rearward) until the surface of each table extension is even with surface of table top
and front edge of table. (See figure 9.) Tighten nuts on all attaching bolts securely and recheck
to make sure tightening nuts did not permit ex- tension to move.
c.Installation of fence guide bar, rack and switch box support. (See figure 10.)
(1)Insert a
a spacer. The guide bar should be positioned so the scale faces upward, and is readable from the front of the saw. (See figure 10.)