1.Attachthecorrugatedhosewith
outletlocateddirectlyabovetheinfla-
torON/ OFF switch on the back of the 1150.
2.The main accessory nozzle attached to the corrugated hose accommo- dates up to 4 sizes. If another size is needed an additional nozzle can be attached to the end of the main accessory nozzle.
3.Insert the nozzle into the product to be inflated.
4.Push the inflator switch to the ON position and inflate product.
5.When product is inflated to the de- sired level, push the inflator switch
to the OFF position and remove the nozzle.
ESTIMATED TIME FOR
INFLATING*
24" Beach | Ball | 1 to 3 minutes | |
Pool Raft |
| 4 to | 6 minutes |
air mattress | 4 to | 8 minutes | |
*Times may vary depending on size and product features.
USING THE DEFLATOR
1.Attach the corrugated hose with the end adapter to the
outlet which is located on the right side of the 1150.
2.The main accessory nozzle attached to the corrugated hose accommo-
dates up to 4 sizes. If another size is needed an additional nozzle can
be attached to the end of the main accessory nozzle.
3.Insert the nozzle into the item to be deflated.
4.Push the inflator switch to the ON position and deflate item.
5.When product is deflated to the de- sired level, push the inflator switch to the OFF position and remove the nozzle.
USING THE BUILT-IN LIGHT
1.Position the 1150 on a flat, stable sur- face near the intended work area.
2.Push the Light/Display switch to the LIGHT position. The light will turn on and illuminate your work area.
3.Push the Light/Display switch to the OFF position when work is completed.
4.Chargethe 1150 as soon as possible after using the
NOTE: With a fully charged internal bat- tery, the
BEFORE USING THE INVERTER
Important Safety Instructions:
•Keepthe 1150 inverterwell ventilated in order to properly disperse heat gener- ated while it is in use. Make sure there are several inches of clearance around
the top and sides and do not block the vents on the back of the 1150.
•Make sure the 1150 is not close to any potential source of flammable fumes, gases or clothing.
•Keep the 1150 dry.
•DO NOT allow the 1150 to come into contact with rain or moisture.
•DO NOT operate the 1150 if you, the 1150, the device being operated or any other surfaces that may come in contact with any power source are wet. Water and many other liquids can conduct electricity, which may lead to serious injury.
•Do not place the 1150 on or near heat- ing vents, radiators or other sources of heat.
•Do not place the 1150 in direct sunlight. The ideal air temperature for operation is between 50 ° and 80°F.
•Do not use inverter near open engine compartment.
•Do not modify theAC receptacles in any way.