110V AC Electrical Device Example RUN-TIME Chart

110V AC ELECTRICAL DEVICE EXAMPLE RUN-TIME CHART

	Appliance Type			Estimated Wattage		Estimated Time*
Spotlights,	Sump	Pumps,	DVD Players	100	Watts	1.5 Hours
Faxes, TVs, Small Power Tools				150	Watts	1.25 Hours
Computer	Printer,	Medium	Power	200	Watts	55 Minutes
Tools, Blenders

The maximum continuous load is 400 watts.

*NOTE: Estimated run-times. Actual time may vary. Times are based on the internal battery being fully charged.

DIGITAL DISPLAY FUNCTIONS

1.Portable Power 1150 - To check the internal battery's status, press the display switch on the front of the 1150. The display will show the charge percentage of the internal battery.

2.Vehicle- For the first 5 seconds, the display shows the vehicle's battery power level in a percentage.

3.Vehicle and Portable Power 1150 - After 5 seconds, the display blinks and switches to show the combined total starting power of the vehicle and 1150 batteries.

You have 10 seconds to attempt to start your vehicle from the time you turn your key. You can crank as many times as necessary during these 10 seconds. After that time, the clamps will shut off and there will be no power available for one minute. The display will first show a 10-second countdown, then a 60-second countdown. This cycle will repeat itself until there is no power left in the Portable Power battery. See Page 4 for further starting details.

4.AC Power- When using the 1150 inverter, the display shows the 1150 's battery percentage of charge. When the 1150 is clamped to an external battery and the inverter is on, the dis- play blinks and shows the combined power level of the 1150 battery and the external battery.

CHARGING INTERNAL BATTERY

This Portable Power 1150 comes with a sealed, non-spillable maintenance-free lead-acid battery. This internal battery is specifically designed to deliver high power jump-starting as well as repetitive deep cycling performance.

To charge the Portable Power 1150 inter- nal battery:

1.Check the internal battery's charge level by pressing the switch marked DISPLAY. The Digital Display will show the battery's percentage of charge.

NOTE: Internal battery's status Dis- play is most accurate when the Por- table Power 1150 has been discon-

nected from all devices and charging sources for at least 30 minutes.

2.Using a proper extension cord, con- nect the cord to the charge plug and

then plug the cord into a properly wired and live 110Vac/60Hz wall outlet.

CAUTION: Operating the Portable Power 1150 while the internal battery is being charged may cause perma- nent damage to the 1150.

3.While the Portable Power 1150 is charging, the battery's percentage of charge will be displayed. When the internal battery is fully charged the display will show 100. The Portable Power 1150 is then ready to use or store. Complete charging may take up to 72 hours. If there is an error while charging, £x9 Err will be dis- played.