Sears 200.71488 owner manual Replacing the BUILT-IN Light, Customer Technical Assistance

4, Once the battery is fully charged, the built-in charger automatically switches to float-mode monitoring, which trickle charges the battery and keeps it fully charged without over- charging so the Portable Power 1150 may be left permanently connected to the wall outlet.

The internal battery may also be charged while you drive using just the male-to- male accessory cable (included). Insert one end of the accessory cable into the 12V DC power outlet and the other end into the vehicle's accessory outlet (lighter socket). Completely disconnect the accessory cable when the engine is not running.

Charge the 1150 internal battery before first use and after every use thereafter.

The internal battery will gradually self-dis- charge (lose power) over time, especially in warm environments. Leaving the battery in a discharged state may result in perma- nent battery damage. To ensure satisfac- tory performance and avoid permanent damage, charge the internal battery every 2 to 3 months. The Portable Power 1150 may be left permanently connected to the AC wall outlet. Store in a cool dry place.

REPLACING THE BUILT-IN

LIGHT

To replace the built-in light bulb:

1.Turn the light off.

2.Pop out the protective plastic lens cover.

3.Gently grasp the bulb and twist

counter-clockwise one quarter-turn to unscrew the bulb.

4.Insert a replacement bulb of the same type and rating, and twist clockwise

one quarter-turn to screw in the new bulb.

5Test the light by switching the light on and off.

6.Replace the lens cover.

CUSTOMER TECHNICAL

ASSISTANCE

Customer technical assistance is available Monday-Friday, 7 am to 4:30 pm Central Time by phoning 1-800-SEARS-64.