Emerson KF180 owner manual Preset Memory Feature, General, Installation of Battery

BP7284, Sturbrige, KF180 7/31/06 10:52 AM Page 4

2. Remove the fan motor and housing assembly from the protective plastic bag. Place the fan assembly into the lower foam pad with the bottom of the motor facing up.

The lower foam pad serves as a holder for the fan during the first stages of assembly.

Preset Memory Feature

Your remote control receiver is equipped with a preset memory feature. The receiv- er will remember the light intensity and fan speed when the light and fan are turned off from the wall switch. When the wall switch is turned back on, the lights and fan will resume operation as they were prior to the

General

switch being turned off.

Your Emerson ceiling fan comes equipped	Installation of Battery
with a remote control transmitter and a

remote control receiver. This remote con- trol systems is designed to control your ceiling fan speed and light intensity.

NOTE: An optional SW101 Wall Control (not supplied) may also be used with the remote control receiver supplied with your ceiling fan.

IMPORTANT

This Owner’s Manual is divided into two sections. The first section,

REMOTE CONTROL PROCEDURES, describes how to install the 9-volt alka- line battery (not supplied) in the remote control transmitter, and how to set the operating frequency of the transmitter and receiver. These instructions must be performed prior to the installation of the ceiling fan as described in the second section, CEILING FAN PROCE-

DURES.

1. Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 1).

2. Engage the connector in the transmitter with the terminals of a 9-volt alkaline battery (not supplied).

	RECEIVER
	CODE
	SWITCH
SWITCH	ON
LEVERS	1 2 3 4
BATTERY		e
		y
COVER		r
		B
		t
		t
		a
	BATTERY
	CONNECTOR	BATTERY
	REMOTE CONTROL
Figure 1	TRANSMITTER

REMOTE CONTROL

PROCEDURES

General

The remote control system is designed to separately control your ceiling fan and light intensity. There are four push buttons on the transmitter (HI, MED, LOW, OFF) to set the fan speed and turn the fan off. The

light push button turns the light on and controls the light intensity. The red indicator light will illuminate while any but- ton is pressed, indicating that the battery is good.

Setting Operating

Frequency of Transmitter

and Receiver

Your remote control transmitter and receiver have code switches which must be set on one of 16 possible code combi- nations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Do not use this setting. Change the switch settings as follows:

1.On the remote control transmitter, locate the code switch just above the battery compartment (Figure 1).

4