Emerson CF930ORB01, CF930BS01, CF930WW01 Setting Operating Frequency of Wall, Control and Receiver

Page 12
Setting Operating

Setting Operating

Frequency of Wall

Control and Receiver

(Figure 18)

Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as follows:

Control and ReceiverInstallation of Wall 1. Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

Installation of Wall

Control

SINGLE-POLE INSTALLATION

(Figure 19)

HOT

BLK

FAN/LIGHT

 

WALL CONTROL

 

 

EMERSON

BLACK

 

 

 

BLACK

LOAD

NEUTRAL

 

 

GROUND

 

 

 

REMOTE CONTROL

 

 

RECEIVER LOCATED

 

 

WITHIN THE CEILING

 

 

COVER

 

 

 

Figure 19

2.In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

ANTENNA WIRE

ON

1. Disconnect power at circuit breaker or remove fuse.

SINGLE-POLE INSTALLATIONManual background 2. Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from control. Do not attempt to disconnect any wires not already connected to existing control.

3. Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.

RECEIVER

CODE

WALL CONTROL

SWITCH

LEVERS

 

 

4

3

2

1

 

 

!WARNING

ON

RECEIVER

SWITCH LEVERS

1 2 3 4

CODE

ON

SWITCH

 

WALL

CONTROL

Figure 18

Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control.

Manual backgroundManual background 4. Connect one black wire of wall control to the “hot” wire. Securely connect wires with wire connectors supplied (Figure 20).

Manual backgroundManual background 5. Connect one black wire of wall switch to the “load” (black) wire in wall box. Securely connect wires with wire connector supplied.

Manual backgroundManual background 6. Screw wall control into wall box and install decorator style faceplate (included). Leave wall control in “OFF” mode until fan installation is completed.

12

Image 12
Contents Page Page Supplied Two 60-wattcandelabra bulbs l Page General Ceiling Fan ProceduresHow to Assemble Your Ceiling Fan Electrical RequirementsPage Page Page How to Wire Your Ceiling Fan SUPPLY WHITE WIRE NEUTRAL Page Setting Operating Frequency of Wall Installation of Wall ControlSINGLE-POLEINSTALLATION Control and Receiver3-WAYINSTALLATION 3-WAYWIRlNG DIAGRAM NEW CONSTRUCTIONOperating Your Ceiling Fan STANDARD WIRING FOR EXISTING3-WAYCONTROL MaintenanceAccessories IMPORTANT CARE INSTRUCTIONS for your Ceiling FanPage 762670-5 TROUBLE PROBABLE CAUSESUGGESTED REMEDY Trouble ShootingLIMITED WARRANTY What The Warranty CoversHow Can You Get Service What Is Not Covered