Emerson CF930ORB01, CF930BS01, CF930WW01 manual

Page 6
Figure 2

Manual backgroundManual background 1. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the clevis pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5.

PIN

HANGER

BALL

DOWNROD

SETSCREW

SETSCREW (2)

CLEVIS PIN

Figure 2

DOWNROD

HAIRPINPIN CLIP

CLIP

MOTOR

COUPLING

MOTOR

COUPLING

Figure 1

Manual backgroundManual background 2. Loosen setscrew in motor coupling if necessary. Separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 2). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull on the downrod to make sure the clevis pin is properly installed.

Manual backgroundManual background 3. While pulling up on the downrod, securely tighten the two setscrews in the motor coupling (Figure 3).

NOTE: The setscrews must be properly installed as described above, or fan wobble could result.

Manual backgroundManual background 4. Make sure the grommet is properly installed in the coupling cover then slide the coupler cover on the downrod until it rests on the motor housing. Place the ceiling cover over the downrod. Be sure both the ceiling cover and the coupler cover are oriented correctly (Figure 3).

CEILING

CANOPY

!WARNING

It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 2) could result in the fan falling.

HAIRPIN

COUPLER

CLIP

COVER

MOTOR

CLEVIS PIN

COUPLING

 

 

SETSCREW (2)

Figure 3

6

Image 6
Contents Page Page Supplied Two 60-wattcandelabra bulbs l Page How to Assemble Your Ceiling Fan GeneralCeiling Fan Procedures Electrical RequirementsPage Page Page How to Wire Your Ceiling Fan SUPPLY WHITE WIRE NEUTRAL Page SINGLE-POLEINSTALLATION Setting Operating Frequency of WallInstallation of Wall Control Control and Receiver3-WAYINSTALLATION 3-WAYWIRlNG DIAGRAM NEW CONSTRUCTIONOperating Your Ceiling Fan STANDARD WIRING FOR EXISTING3-WAYCONTROL MaintenanceAccessories IMPORTANT CARE INSTRUCTIONS for your Ceiling FanPage 762670-5 SUGGESTED REMEDY TROUBLEPROBABLE CAUSE Trouble ShootingHow Can You Get Service LIMITED WARRANTYWhat The Warranty Covers What Is Not Covered