Husqvarna YTH2242TDRF owner manual Unassembled Parts, Tools Required for Assembly

Page 5

UNASSEMBLED PARTS

Keys	Slope Sheet
Keys

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)	1/2" wrench	Tire pressure gauge
(2)	7/16" wrenches	Utility knife
		Pliers

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TOREMOVETRACTORFROMCARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton .

•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

TO CHECK BATTERY (See Fig. 1)

•Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

LABEL

Fig. 1

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

• For battery and battery cable installation see "RE-	Fig. 2
PLACING BATTERY" in the "Service and Adjustments"
section in this manual.

5

Image 5

Contents YTH2242TDRF Safe Operation Practices for Ride-On Mowers Safety RulesSafe Handling of Gasoline General ServiceIII. Children Table of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking BRAKESee Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D SeeTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsBefore Starting the Engine Battery INDICATOR/CHARGING Plug See FigCheck Engine OIL Level ADD GasolineAutomatic Transmission Warm UP To Start Engine See FigPurge Transmission Mowing Tips Maintenance Schedule MaintenanceLubrication Chart General RecommendationsTractor BatteryBlade Care Blade Removal See FigEngine Transaxle MaintenanceBelts Transaxle Pump FluidCleaning Deck Washout Port See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Raise attachment lift lever to highest position To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Other StorageFuel System Engine OILProblem Cause Correction TroubleshootingEngine continues to Service Notes KEY Part Description DecalsWheels and Tires SCH12 SchematicElectrical Tractor Model NO. YTH2242TDRF 96041023700, Product no 41KEY Part Description Chassis Tractor Model NO. YTH2242TDRF 96041023700, Product no 41 Drive 183 532 13 Spacer Split Engine Spark Arrester KITEngine Power Rating Information Steering Assembly 532 43 Wheel, Steering 532 43 Seat Seat Assembly Mower LiftMower Deck Tractor Model NO. YTH2242TDRF 96041023700, Product no 41 Service Notes Suggested Guide for Sighting Slopes for Safe Operation 01.22.14 JM