Husqvarna K950 CHAIN manual Assembly, How to tension the chain How to change the chain and rim

Page 13

ASSEMBLY

How to tension the chain

How to change the chain and rim

Untensioned chain.

Start with opening the adjust screw cover.

Pull the handle backwards.

Continue to move the handle down-wards until you start to tension the chain.

Hold the bar upwards as you move the handle forward.

Tighten the adjust screw.

Close the adjust screw cover.

Lift out the top of the inner handle and move it anti- clockwise.

Unscrew the outer handle.

Remove the cover.

Remove the bar and chain.

Remove the spring holding the two "half-moons" using a screwdriver.

Remove the "half-moons", the cup and rim.

Remove the drive wheel.

Assembly takes place in the reverse order.

English – 13

Image 13

Contents Operator’s manual Symbols on the cut-off saw Symbol ExplanationSymbols in the Operators Manual Contents MACHINE’S Safety Equipment Safety InstructionsStop switch Personal Protective EquipmentThrottle lock MufflerStorage General Safety InstructionsBasic safety precautions Fuel safetyGeneral Working Instructions Filling/Fuel mixture/StorageWet cutting Using CuttingWorking speed Cutting techniqueEfficient cutting Care and storage KickbackWater cooling GeneralDiamond chains Cutting EquipmentGlazing What is what on the machine? What is WHAT?How to tension the chain How to change the chain and rim AssemblyHow to change the clamping force of the bar Fuelmix Fuel HandlingFuelling Start and stop Start and StopFunctioning, Final setting Operation MaintenanceFinal setting of the idling speed T CarburetorAir filter Fuel filterReplacing a broken or worn starter cord StarterTensioning the recoil spring Replacing a broken recoil springCooling system Ignition systemSpark plug MufflerWeekly maintenance Daily maintenanceMonthly maintenance Cutting equipment Technical DataEU declaration of conformity Only applies to Europe 108 88