Hobart Welding Products OM-2208 manual Meter Functions For CC/CV Model

4-3. Meter Functions For CC/CV Model

NOTE

The meters display the actual weld output values for approximately three seconds after the arc is broken.

Mode		Meter Reading At Idle			Meter Reading While Welding
		V		A	V		A
Scratch		80.0		85	10.3		85
Start TIG
	Actual Volts (OCV)		Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
Lift-Arc TIG		7.0		85	10.3		85
		Actual Volts	Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
TIG				85	10.3		85
		Blank	Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
MIG		24.5			24.5		250
		Preset Volts		Blank	Actual Volts	Actual Amps
		V		A	V		A
Pulsed		PPP		PPP	24.5		250
MIG
	Pulse Display		Pulse Display		Actual Volts	Actual Amps
		V		A	V		A
CC				85	24.5		85
		Blank	Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
Stick		80.0		85	24.5		85
	Actual Volts (OCV)		Preset Amps		Actual Volts	Actual Amps
		V		A	V		A
V-Sense		80.0			24.5		250
Feeder
	Flashes OCV And Preset			Blank	Actual Volts	Actual Amps

4-4. Mode Switch Settings For CC/CV Model

NOTE

The Stick and CC modes provide the Adaptive Hot Start feature, which automatically increases the output amperage at the start of a weld should the start require it. This eliminates electrode sticking at arc start.

Mode Switch Setting	Process	Output On/Off Control
Scratch Start TIG	GTAW	Electrode Hot
Lift-Arc TIG	GTAW – See Section 4-7	Electrode Hot
TIG	GTAW With HF Unit, Pulsing Device, Or Remote Control	At Remote 14
MIG	GMAW	At Remote 14
Pulsed MIG	GMAW-P (Requires an external pulsing device.)	At Remote 14
CC	Stick (SMAW) With Remote On/Off	At Remote 14
Stick	SMAW	Electrode Hot
V-Sense Feeder	MIG (GMAW) With Voltage Sensing Wire Feeder	Electrode Hot

OM-2208 Page 18