8.With assistance, raise bed and leg assembly
Bed and leg assembly is heavy. Use care when lifting.
9.Rotate the leveling feet as needed to establish level for the lathe.
10.Install headstock, toolrest base and tailstock, and both stop bolts (B, Figure 3).
7.5Tool caddy
Install tool caddy (Figure 7) to either end of lathe with two screws and washers
Figure 7
7.6Brackets
1.Install guard bracket (C, Figure 8) with two screws and lock washers
2.Install comparator bracket (D, Figure 8) to tailstock with fasteners
3.Install locking handle (E, Figure 8).
See section 9.11, “Comparator” for further information.
Figure 8
7.7Lamp holder set
1.Install shaft of lamp holder (F, Figure 9) into guard bracket hole, and tighten handle (G).
2.Install collar (H) beneath and tighten set screw on collar.
Figure 9
To install lamps:
3.Insert stud (J, Figure 10) into plate and secure with lock washer and nut (K/L).
4.Lift up collar (M) on lamp arm while pushing arm down completely onto stud. Push collar back down to secure.
Figure 10
7.8Guard
The guard must always be used in operations that will allow its use.
See Figure 11.
1.Loosen set screw of outer collar (N) and remove collar.
2.Insert guard support rod into guard bracket while lifting up on plunger (O). Release plunger and it will snap into position as you slide support rod farther in.
3.Reinstall collar (N) on end of guard support rod and tighten set screw.
12