Figure a

SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS

1.MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit. Make sure there is adequate surrounding workspace. Always keep the work area free of obstructions, sawdust, grease, oil, trash, and other debris. Do not use the Mini Bench Lathe in areas near flammable chemicals, dusts, and vapors. Do not use the Mini Bench Lathe in a damp or wet location.

2.THE MINI BENCH LATHE IS FACTORY PRE-WIRED FOR 120 VOLT AC USAGE. The Power Cord for this product is equipped with a 120 Volt AC,

2-Prong Plug. Never modify the Plug in any way. To comply with the National Electric Code, and to provide additional protection from the risk of electrical shock, this product should only be connected to a 120 Volt AC, electrical outlet that is protected by a Ground Fault Circuit Interrupter (GFCI).

3.DO NOT ABUSE THE POWER CORD. Do not use the Power Cord to pull its Plug from an electrical power outlet. Keep the Power Cord away from heat, oil, sharp edges, and moving parts. Route the Power Cord safely. Do not route the Power Cord where it can be walked on or tripped over. Replace a damaged Power Cord immediately.

4.IF AN EXTENSION CORD (not included) IS USED, MAKE SURE TO USE ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND LENGTH . (See Figure A.)

5.REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Power Switch (part #2) is in the “OFF” position before plugging the Power Cord into a grounded, 120 Volt AC, electrical outlet.

(See Figure B, and Assy. Diagram.)

6.PRIOR TO STARTING THE MINI BENCH LATHE, MAKE SURE ALL ADJUST- ING KEYS AND WRENCHES ARE REMOVED FROM THE TOOL.

SKU 04019

PAGE 4