Specifications
Motor: 2HP, 1700 RPM, Reversible |
| Max. Tool Shank Size: 3/4” x 3/4” Lathe Bit | ||||
| ||||||
Power Required: 220 V / 60 Hz, |
| Tool Post Travel: Max. 3.5” , 0.001” per scale | ||||
Drive: Belt/Gear |
| Cross Slide Travel: 5.9”, 0.002” per scale | ||||
Swing Over Bed: 12” |
| (Total Cut) | ||||
Swing Over Gap: 18.8” |
| Longitudinal Feed Range: 0.005” - 0.0165” /R | ||||
Width of Gap: 7” |
| (16 Steps) | ||||
Center to Center: 37” |
| Cross Feed Range: 0.0014” - 0.0049 /R | ||||
Spindle Bore Taper: MT5 |
| (16 Steps) | ||||
Spindle Bore: 1.5” |
| Tailstock Travel: Max 3.6” | ||||
Three Jaw Chuck Diameter: 6” |
| Tailstock Spindle Bore Taper: MT3 | ||||
Spindle Speed: 18 Speed |
| Thread Indicator: Yes | ||||
Spindle Speed Range: |
| Thread Feeding: | ||||
72; 82; 147; 168; 240; 275; 325; 370; 415; 476; |
| SAE: 4 - 112 TPI, Total 40 Setting | ||||
660; 760; 850; 975; 1080; 1240; 1380; 1600 |
|
| Metric: 0.25 - 7.5 mm, Total 19 Setting | |||
Bed Way Heat Treatment: |
| Net Weight: 838 lb. | ||||
Tool Post Type: |
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
| |||
| Accessories |
| ||||
(1) | Steady Rest |
| (5) | Hex Wrenches (3, 4, 5, 6, 8 mm) |
| |
(1) | Follow Rest |
| (1) | Screwdriver |
| |
(2) | Dead Center: #3 |
| (1) | Oil Gun |
| |
(1) | Center Sleeve: #5 / 3 |
| (5) | Changing Gears: T30, T32, T40 (2 |
| |
(1) | Live Center: MT3 |
|
|
| pcs), T127/120 |
|
(1) | 6” |
| (1) | Face Plate |
| |
(1) | Back Plate for |
| (1) | Splash Guard |
| |
(1) Tool Post Wrench |
| (1) | Oil Tray |
| ||
(1) | Double End Wrenches |
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| Save this manual | |||||
You will need the manual for the safety warnings and cautions, assembly instructions, oper- ating procedures, maintenance procedures, trouble shooting, parts list, and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover.
Keep both this manual and your invoice in a safe, dry place for future reference.
READ ALL INSTRUCTIONS BEFORE USING THIS TOOL!
Notice
The Warnings, Cautions, and Instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be sup- plied by the operator.
| For technical questions, please call | REV 02/07 |
SKU 43681 | Page |