The 28” bed extension and 3/4HP motor allow turning pieces up to 50” long, a capacity rivaling far more expensive machines.
Bed Extension
Adding the JWL-1220BE 28” (#708377) bed extension expands the JET JWL-1220VS between center capacity to nearly 50“, exceeding that of many full-sized 12” lathes! The 3/4hp motor has the power needed to handle those long pieces.
The JWL-1220BE 28” bed extension comes with the necessary hardware for installation but goes a step further to make this process easy. A hanging plate on the mating end of the extension makes aligning it to the JET JWL-1220VS bed much easier when a second set of hands are not available. The mating face also has hex head socket screws pre-
installed that make aligning the JWL-1220BE 28” bed extension perfectly much easier. Even the rubber-cushioned feet on the bed extension are adjustable to be sure your newly configured JET JWL-1220VS is stable on irregular surfaces.
Stand
The stand features wide-stance, rubber-tipped feet (left) that adjust for irregular floors. The mounting plates (right) are adjustable up and down to fine-tune spindle height for comfort.
finished to retain its good looks while resisting corrosion
We offer the JWL-1220S (#708378) Adjustable Stand that makes your JET JWL- 1220VS a rock-solid, stand- alone machine. Built from heavy walled square steel tubing with fully welded plate steel joining plates, the JWL-1220S is beautifully
for many years to come.
The JWL-1220S comes with rubber tipped adjustable leveling feet to dampen vibrations and resist moving. The lathe mounting plates are adjustable so spindle height can be set to between 43 and 45” above the floor for maximum comfort.
