Jet Tools JWBS-20 owner manual Fence Assembly and Adjustment

Page 9

Fence Assembly and Adjustment

1.Attach the fence (A, Fig. 10) to the fence body (B, Fig. 10) with four 5/16” x 3/4” hex cap bolts, four 5/16” lock washers, and four 5/16” flat washers.

2.Thread a hex nut (D, Fig. 11) onto the pad’s threaded stud (E, Fig. 11) and insert through the fence and rear hook (F, Fig. 11). Secure in place using a hex nut, lock washer and flat washer (G, Fig. 11).

Note: The hook should be adjusted so that it overlaps the rear rail by approximately 1/8”.

3.Place fence assembly onto the guide tube. The rear hook should engage the rear rail.

4.Check the clearance between the table and the fence. The gap should be the same at the front of the table as it is at the rear. If the gap width is different, adjust the foot at the rear of the fence until the gap width is the same, Figure 12.

Note: You can also adjust the front rail, or rear rail up, or down to achieve the proper clearance.

5.With a square verify the fence face is perpendicular to the table top. If it is not the front rail will need to be adjusted parallel to the table top. This can be accomplished by measuring from the top of the table to the top of the front rail. The measurement should be the same at both ends of the table.

6.Move the fence assembly so that it aligns parallel to the blade, and lock the fence by pushing the lock handle down, Figure 10.

7.Loosen the four hex cap bolts that hold the fence, to the fence body, and align the fence to the blade. Tighten the four hex cap bolts.

8.Check to see that the pointer (C, Fig. 10) is aligned with the zero marking on the guide rail. If adjustment is necessary loosen the screw that holds the pointer in place and line up to the zero mark. Tighten the screw.

Note: If you cannot get the pointer lined up with the zero mark you can slide the guide tube and front rail left, or right to achieve the proper setting.

9

Image 9
Contents JWBS-20 Woodworking Bandsaw Warranty & Service JET Group WarrantyMore Information Page Specifications Table of ContentsUnpacking and Setup Contents of Shipping ContainerTools Included for Assembly Tools Required for Assembly & AdjustmentsUpper Bearing Guide Adjustment Assembly and SetupMounting the Table Lower Bearing Guide AdjustmentRail Assembly Adjusting 90 Degree Table StopFence Assembly and Adjustment Resaw Guide Height Scale AdjustmentMiter Gauge Tilting the TableChanging Blades Adjusting Blade Tension Adjusting Blade TrackingDisconnect machine from the power source, unplug Adjusting Belt Tension Brake PedalReplacing Belt Electrical Connections MaintenanceTroubleshooting Possible Cause Solution Upper Wheel Assembly Index Part Description Size Qty Lower Wheel and Motor Assembly JWBS20-201 JWBS20-84 Blade Guides Assembly JWBS20-304 JWBS20-357 Hex Socket Cap Screw Table Assembly JWBS18-MGCP Electrical Schematic 230V, 1 Ph