Jet Tools JWBS-18X-3 operating instructions Handwheel, Mounting the Table, Rail Assembly

Page 10

Assembly

Handwheel

Attach the handle (A, Fig. 3) to the handwheel (B, Fig. 3).

Mounting the Table

Important: The table is heavy. Mounting with the help of another person is recommended.

Referring to Figures 4 and 5:

1.Remove the table insert (A) and tapered pin (B).

2.Slide the table so the saw blade (D) passes through the slot where the tapered pin (B) was located.

3.Rotate the table 90 degrees so that the miter slot (C) is parallel to the blade (D) and to the right of the blade when facing the band saw as viewed in Figure 5.

4.Line up the table (H) to the trunnions so that the bolts (F) feed through the support bracket

(E). Secure the table with two lock knobs (G). Reinstall the table insert (A) and tapered pin (B).

Rail Assembly

Referring to Figure 6:

1.Attach the front rail (F) to the cast iron table with two 1/4” x 5/8” hex cap screws, two 1/4” lock washers, and two 1/4” flat washers. The screws should be in approximately the center of the slot. Hand-tighten only at this time.

2.Attach the rear rail (G) to the table with two 1/4” x 5/8” hex cap screws, two 1/4” lock washers, and two 1/4” flat washers. Screws should be in approximately the center of the slot. Hand- tighten only at this time.

3.Push the front and rear rails up as far as they will go.

4.Using a 10mm wrench, tighten the four hex cap screws holding the front and rear rails to the table. Do not over-tighten the screws.

5.Attach the guide tube (H) to the front rail with five 1/4” x 5/8” hex cap screws, five 1/4” lock washers, and five 1/4” flat washers. Screws should be in approximately the center of the slot.

Hand-tighten the guide tube only at this time. You will be instructed to secure it later in the Fence Assembly and Adjustment section.

10

Figure 3

Figure 4

Figure 5

Figure 6

Image 10
Contents Band Saw Warranty More Information WMH Tool Group WarrantyTable of Contents Page Page Introduction Specifications JWBS-18XGrounding Instructions HP Single Phase MotorVolt Operation Extension cords FeetContents of Shipping Container UnpackingHandwheel AssemblyRail Assembly Mounting the TableFence Assembly and Adjustment Assembling the Fence to Fence BodyFence Adjustment Resaw Guide Miter GaugeAdjustments Adjusting 90 Degree Table StopInstalling/Changing Blades Blade Tension Blade TrackingOverview Bearing Adjustments Upper Bearing AdjustmentsLower Bearing Adjustments Guide Gearings AdjustmentBlade Lead Replacing the V-Belt Belt TensionElectrical Connections Pulley AlignmentRipping General ProcedureOperation CrosscuttingResawing Saw Blade SelectionMaintenance Blade BreakageBlade Selection Guide Troubleshooting TroubleOptional Accessories Band Saw Blades Replacement PartsParts List Upper Wheel Assembly Index No. Part No Description Size QtyUpper Wheel Assembly Parts List Lower Wheel and Motor Assembly JWBS18X-MFCLower Wheel and Motor Assembly Parts List Blade Guide Assembly JWBS18DX-357 Blade Guide Assembly Parts List Table and Fence Assembly 16-18x2 Table and Fence Assembly Electrical Connections Page WMH Tool Group