Jet Tools JWBS-18X-3 Fence Assembly and Adjustment, Assembling the Fence to Fence Body

Fence Assembly and Adjustment

Assembling the Fence to Fence Body

Referring to Figure 7:

1.Attach the fence (A) to the fence body (B) with four 5/16” x 3/4” hex cap screws (C), four 5/16” lock washers (D), and four 5/16” flat washers

(E). Hand-tighten only at this time.

Figure 7

Assembling the Rear Hook

Referring to Figure 8:

2.Thread a 1/4"-20 hex nut (B) onto the pad’s threaded stud (A) and insert through the fence (C) so the threaded stud is now inside the fence.

3.Place the rear hook (D) on the threaded stud.

Finish the assembly by placing a 1/4" flat washer (E), 1/4" lock washer (F) and 1/4" hex nut (G) on the threaded stud and finger tighten.

Note: Adjust for a gap of approximately 1/8" between the pad (A) and hook (D) and as shown in the inset.

4.Tighten the assembly using two 10mm wrenches.

Figure 8

11